The 35 mm by 35 mm display area (approximately 1.4 in x 1.4 in) features a sixteen LED array that can display any of 16 shapes in 8 different colors.
The eight colors are: Orange, Red, Green, Yellow, Blue, Lilac, Turquoise, and White. The standard shapes are a cross, forward slash, back slash, square, circle, small dot, vertical bar, horizontal bar, and ALL ON as well as the random shapes shown below.
This key may be used in the standard 80004 series modular test chambers or on custom panels as shown here.
Specifications:
Mechanical
- Modular Panel: 4 Unit (3" H x 3.245" W) (7.78 x 8.24 cm)
- Viewing area: 35 mm x 35 mm (1.38" x 1.38")
Electrical Connections
- Power: 12 – 28VDC
- Key Press Report: Grounds Input through de-bounce filter (Normal and Inverted)
- Color Control: Requires 3 Outputs
- Shape Selection: Requires 4 Outputs
- Image Latch: The image represented by the seven data lines above will be transferred to the LED array when this line is switched from a high voltage to ground. The image will remain as long as the line is held low. The image will be off when ground is removed.
Stimulus Array
- 4 X 4 array of RGB LED’s on a 7mm pitch with each LED appearing as a 5mm dot.
Pecking Key
- Material: Clear 3mm Perspex with a visible size of 35mm square.
- Travel: Approximate travel of 2.2mm (measured at the bottom of the key).
- Trigger Point: An approximate trigger point at 0.6mm of travel (measured at the bottom of the key).
- Response Switch: Hinged roller type V4 microswitch
- Electrical life: better than 100,000 presses.
- Maximum registered responses per second: >10.
- Force required to register a response (measured in the center of the key): 50cN.
